Interior Stone Carpet Pore Fillers
ANOX61-F-UV is a single-component acrylate to seal pores in stone carpet, it has a liquid impermeability. After the curing is complete, a clear and transparent film layer is formed.
If there is a floor heating, close it one day before the application of quartz stone carpets begins.
• Resistant to water.
• Stainless / easy to clean.
• Resistance to UV rays.
• It is not resistant to vehicle and motorcycle tires.
Divide with a white wiper.
Never apply with a brush!
Do not apply outdoors!
0.8-1.2 mm: 300 gr / m²
1.5-2.5 mm: 450 gr / m²
2-3 mm: 700 gr / m²
Plastic Buckets of 10 kg of 20 kg
Transparent Stone Carpet Primer
2-Component ANIX-61 primer for Quartz carpet.
PREPARATION OF MIXTURE:
Mixing the material is one of the most critical stages in the processing, and must be done with extreme care. When contents are not used fully, the mixing ratio will be incorrect and the end product will not be of an optimal quality. The only appropriate way of obtaining the right balance between components A and B, is by weighing each using sufficiently accurate scales. Then mix The quartz stone with A / B for 3 minutes until a homogeneous mixture is formed.
• Two component A + B, 4/1
• Resistant to UV rays.
• Resistant to weather conditions.
• High wear resistance.
• Anti allergic.
A successful application can be achieved with the correct surface preparation and the correct use of materials.
The surface must be free of non-stick materials, dust, oil, weak parts and the application surface must be dry. After the application it must be protected for effects such as water en dust etc. for 4 hours.
1 m² - 12.5 kg Quartz Stone Sarpet - 4/1 (800grA + 200gr B)
20 kg A - 5 kg B
Acrylic Vertical Primer for Quartz Stone Carpet
Quartz stone carpet acrylate vertical binder. It’s specally produced with high viscosity for wall applications. After drying, the glue looks glossy.
100% hardening after 48 hours
Add 1.000 gr to a 1 m2 (12.5 kg) Quartz Stone
10 kg plastic buckets
Aliphatic and polyurethane-based, is wear-resistant, thanks to the transparent top layer has a high UV resistance, a wide operating temperature range (-40 C to + 80 C) and a elasticity of 250%.
Surfaces to be used must be dry, clean, strong and load-bearing. All dust, oil, grease, paint, etc. To reduce adhesion must be thoroughly cleaned before use. The surfaces to be applied must not contain defects such as pits and cracks. After application, the surfaces must be protected from water, rain, dew, snow, hail, etc. until they are completely dry. Mixing should be done for 2 min with a drill whose speed does not exceed 300-400 rpm. Never mix with a high speed drill. The opened packages should be tightily closed and the tins should be stored upside down. All opened tins must be used.
• Resistant to UV rays.
• Resistant to outdoor weather conditions.
• Elastic to -40 C.
• It is one component, it is very easy to apply and repair.
• It is resistant to continuous contact with water and snow.
• Does not fade or discolour over time.
• Walking trails, bike lanes
• Public areas
• Gallery and exhibition areas
• Car parks, auto galleries
• Villas, sites and apartments.
• Application temperature between +5 C and +35 C
• Can be applied with a sutable sprayer compressor equipment or brush
(+23 C, 50% humidity) 12 hours
1 kg - 20 m²
ANIX61-EP / 5 kg. 10kg. 20kg